Setup Eastron SDM120MOD 45A

1

.

Start-up screen

When the energy meter starts up, you will see the following on the display:

After the meter has checked itself, the display will show the total active energy consumption in kWh.

2

.

Parameters to be read out

If you wish to see information other than total active energy consumption, you must use the scroll button. It is located to the left of the display (see image below).

Briefly pressing the button scrolls through the various parameters including Active Energy Consumption (kWh), Voltage (V), Current (A), Active Power (W).

A complete list of parameters can be found in the appendix.

3

.

Configuring the energy meter

To enter setup mode, press and hold the scroll button for 3 seconds.

To navigate through the various settings, briefly press the scroll button.

If you stay in the setup menu for about a minute without doing anything, the meter goes back to the main screen.

4

.

Configure modbus address

The default mode address is 001, as shown above. Hold down the scroll button for 3 seconds to adjust it.

  1. The rightmost digit will blink. Adjust this digit by briefly pressing the scroll button until you have the desired digit. Then press and hold the scroll button for 3 seconds to confirm.
  2. Next, the middle digit will start blinking. Repeat the same steps as for the first digit.
  3. After this, the leftmost digit will start blinking. Repeat the same steps as for the previous digits. After confirming by pressing and holding the scroll button for 3 seconds, you are returned to the setup navigation.

Other settings can be found on the image below. You can also adjust them and confirm the changes using the scroll button

 

5

.

Gebruikershandleiding

6

.

Datasheet

Need Support?

Can’t find the answer you’re looking for? Don’t worry we’re here to help!

Ask For Help
Language Choice Disclaimer

These texts have been automatically translated using advanced AI translation tools. If you notice any inaccuracies or errors, please help us improve by sending a message to hello@calculus.group. Your feedback assists us in enhancing the quality of our multilingual documentation.