1
.
Introduction
A guide to installing C06 gateways in DEIF AGC-200 controllers, or when you replace a C04 with a C06 and want to retain the historical data.
2
.
Register gateway
- Modbus RTU
- Gateway type: "Genset (AGC 200 over RS-485)"
- Slave ID: 10
- Baud rate: 9600
- Modbus TCP/IP
- Gateway type: "Genset (AGC 200 over Ethernet)"
- IP address of the controller: 192.168.2.20
- Slave ID: 10
3
.
Change asset
Go to the current asset whose gateway you want to switch, and then to the "Data Sources" panel.
Is the "Switch data source" button visible?
If yes:
- Press the "Switch data source" button.
- Enter the serial number of the new gateway (in the "With:" field) and press "Swap".
There opens a new screen where you can review the changes one more time. Click "Confirm" to confirm the changes.
When the conversion cannot be performed 100% successfully you will also receive a message. The data sources where the conversion was not successful, need to be filled in manually (how to do this is shown below).
If no:
- Click on the data source's edit button. It is located to the right of the data source name and looks like a pencil.
- At the bottom right of this screen, click the "Add Data Source" button
- By hovering your mouse over a "Data source" (do not click), the raw address appears in a black bar with the Slave Id at the back.
- When adding a new data source, adjust the start date to when the new gateway was built in.
- Customize the other data source (from the old gateway) as well, specify an end date here. This is the date the gateway was replaced.
After this press "Save."